Toyota tis techstream diagnostic3/15/2023 ![]() ![]() Using the SST, repeat a cycle of short and open between terminals Ts and CG ofĭLC3 4 times or more within 8 seconds (refer to the specific vehicle EWD for TS andĤ. If the vehicle is equipped with a M/T, ensure that theģ. ![]() If the vehicle is equipped with A/T, ensure that the shift lever is in the “P” range and The vehicle must remain in a stationary condition throughout the entire process.īe sure to perform the procedure on a level surface with an inclination of less than 1%.ġ. While performing the Zero Point Calibration, do NOT tilt, move, or shake the vehicle. The following manual procedure may be used in the cases where a Diagnostic Tester is Optional method one: Zero Point Calibration Using Jumper wire This post provides two optional methods to do Toyota Zero Point calibration, one is to use Jumper wire, and another one is to do using Toyota TIS techstream cable. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |